Pouring Super Glue into Borax 1

Pouring Super Glue into Borax 1

Everyone has heard about slime from school glue.

But I was thinking what would happen if you use superglue instead of just regular school glue.

Glue has long flexible molecules in it called polymers. These polymer molecules slide past each other as a liquid.

Borax in water forms an ion called the borate ion. When the borax solution is added to the glue solution, the borate ions help link the long polymer molecules to each other so they cannot move and flow as easily.

When enough polymer molecules get hooked together in the right way, the glue solution changes from being very liquidy to a rubbery kind of stuff that we call slime.

I was thinking what would happen if you replace superglue instead of just regular school glue.

So here I have a 2% borax solution by adding 2 grams of borax into 200ml of water:

 

Now I’ll put one drop of superglue into the borax, just to see what happens.

The drop of super glue has turned into jelly. Now let’s add more:

The same thing happened. Then I decided to take it out with forceps:

The superglue instantly dries when it touches the air.

After that, I decided to put a teaspoon of borax into the solution and poured more superglue.

It dried up in the solution fast. I took the chunk of superglue out to inspect it. The superglue felt like hard foam. I pinched it with my hand, there are still some superglue that hasn’t dried inside since the borax can’t touch it.

 

That’s it! I think the experiment was too quick, and a little sloppy so I’ll try this experiment again and I’ll do a better one sometime later.

Also, I’m going to write a scientific report after every and each chemistry experiment. But this one is a little too short so I’m not going to write anything.

And that’s all for now!

Sources:

 

7 Replies to “Pouring Super Glue into Borax 1”

  1. It’s always fun playing around with glue! 😀 And you got some interesting results. 🙂

Leave a Reply Cancel reply

Exit mobile version
%%footer%%